It’s Almost Worth Breaking Your Arm For This Crazy 3D-Printed Cast

It’s Almost Worth Breaking Your Arm For This Crazy 3D-Printed Cast

Plaster casts are bulky, obnoxious, heavy, inevitably sweaty, occasionally pink. In short, they are no fun. But this 3D-printed “Cortex” cast could change all that. Sure, it looks a little like a fishnet stocking, but have you seen a old-fashioned cast lately?

A conceptual project designed by a Victoria University of Wellington graduate with the suspiciously awesome name Jake Evill, the Cortex cast is lightweight, ventilated, washable and thin thanks to its polyamide skeleton. But the bonuses aren’t all for the wearer; the material of Cortex casts could be reused, unlike plaster.

Ideally, computer software would be fed x-rays of the break and 3D scans of the limb, and would design an appropriate cast shape for fixing it up, with the cast’s densest parts concentrated around the actual break. The cast could then be printed out in pieces and assembled around the break with permanent fasteners. When all is said and done, it’d still have to be sawed off as usual.

Then there’s the matter of time. Evill explains it this way:

At the moment, 3D printing of the cast takes around three hours whereas a plaster cast is three to nine minutes, but requires 24-72 hours to be fully set. With the improvement of 3D printing, we could see a big reduction in the time it takes to print in the future.

It sounds pretty good, but I’m seeing just one problem. How are you supposed write hideous signatures in Sharpie on surfaces that skinny? [Dezeen]


The Cheapest NBN 50 Plans

It’s the most popular NBN speed in Australia for a reason. Here are the cheapest plans available.

At Gizmodo, we independently select and write about stuff we love and think you'll like too. We have affiliate and advertising partnerships, which means we may collect a share of sales or other compensation from the links on this page. BTW – prices are accurate and items in stock at the time of posting.